Recenzije

Kupci kažu

Morao sam zamijeniti DIN L8 priključke na kućištu pomoćnog ventila DIN L10 priključcima (po $5), ali radi kako je najavljeno i vrlo sam zadovoljan.

Gdje možemo nabaviti zamjene za one male oštrice ispod njega?

Bobby I. -

Alkemija Ontario Kanada

Ovo su sjajne mašine! Puno snage i okretnog momenta i kvalitetnije od svih kineskih bagera. Imamo nove i rabljene dostupne za najam i/ili prodaju.

Alkemijski build -

Minibager s hidrauličnom lopaticom, Yanmar dizel motor, oko 2,8 tona | CFG-STE35SR

Ova je mašina izvrsna i nemamo nikakvih pritužbi. Koristimo je uglavnom za radove na vodovodnim i kanalizacijskim/septičkim instalacijama. Za tu cijenu radi se o mašini vrlo dobre kvalitete. Zapravo planiramo nadogradnju na sljedeću, veću veličinu mašine koju AGT nudi.

Nik Ruzicka -

Odlična kupnja.

Nije bilo nijednog problema od narudžbe do isporuke. Na prilazu mi je pala hidraulička klizna rampa. Odrezao sam ambalažu i odvezao ga u dvorište. Motorno ulje je bilo u redu, ali hidrauličko je bilo tek dovoljno za rad. Ionako sam ga namjeravao promijeniti. Provjerio sam sve vijke i priključke, nisam našao ništa labavo ni što curi. Ugradio sam hidraulični palac bez problema. Kupio bih ponovno.

mark j. -

Upravo sam to dobio

Upravo sam ga dobio.. još nisam vozio

Michael -

Odličan proizvod, brza dostava

kako je opisano

čarli49 -

My toy

Haven’t had any problems rather than nuts and votes. Being loose did a few modifications works who are never overly heated

Charles mineo -

About 15″ Toothless Bucket for 1 Ton Mini Excavator | AGT-12EX-WD15B

It just right for the Agt works great

julie h. -

Great machine

Very nice mini digger. Small but powerful and perfect for home use.

John Smith -

Decent for price, but not without some issue.

Showed up and throttle control handle broken off, called customer service. No pickup, left voicemail, no reply after a couple days now, not the end of the world, $25 part, just annoying. Fuel shut off left on from factory, engine flooded. When I started it, shiot all the fuel out exhaust. Only ran for a few seconds which is good because there’s no oil in engine. No indication that oil was drained. I don’t suspect leak because there’s no oil all over machine. Couple scuffs in paint from shipping, not AGTs fault. Digger arm a little crooked (about 2° out of plumb). Hour meter not hooked up, probably from jostling during shipping. Thumb kit includes no direction, but reasonably self explanatory except for 3 way diverting valves. Assume they don’t get used, and the lack of adapters for connecting to H15, but there’s a note on ordering screen that states as such, fittings about $8 plus shipping online Also, thumb kit short (1) M25x100 bolt for affixing upper arm included in kit, so find another or get some spacers to make up slop. Rear engine cover panel one of the bolts was stripped out, so I’ll have to replace that. Track control arms bent at slightly different angles so they don’t line up, quite a bit of play in them so I plan on devising some method of stiffening them up, as well as the foot pedals.

All in all for a sub $6k machine it’s not bad, I’m sure more things will come up once I actually get to use it, as it is still in the shipping pallet, but I’m sure nothing anybody with a reasonable amount of mechanical inclination can’t overcome. FYI, the Majic brand Caterpillar Yellow from tractor supply near identical match to paint (if your machine is yellow).

Kevin Real -

Nice machine

I really like most of the features. I did add a cooling fan and replaced the floor mat. The Roto engine is a little hard to start, maybe a choke adjustment issue. Travelling down a slope can be dangerous since the track motors freewheel easily and speed can get out of control.

David -

Pleased

I have about 29 hours on the brush cutter so far. I had t shorten the blades approximately 1/4″ each. It does a very good job of mowing around ponds and road banks. Very pleased so far.

Anonymous -

Works great.

I use it for logs and split firewood. No issues

Mike -

AGT QNT50R

Was surprised by stability of the unit working on a hill

Chris i.V. -

Brush cutter

Used it 15 minutes cutting grass then pump started shootings fluid out. The motor base was broken. I wrote a message to you with picture about motor replacement, so far no response. The made it good, sending a replacement motor.

John K -

Thick

Well built. Arrived fast. Was surprised

Richard W -

The Best Customer Service!!!

The H15R mini excavator was as I expected from watching plenty of YouTube. What I didn’t expect was the excellent customer service. My machine had an unexpected and serious issue. When I found this problem I immediately contacted AGT and they had a tech at my house in 4 days. I’m 5hrs from their Chicago warehouse and their tech drove here with all the right tools and all the right knowledge. I major repair was made in less than an hour.
I had a great sales experience, a great pickup experience and the best repair service. Highly recommend purchasing from AGT Equipment Corp.

Mark W -